Epson T0613 Magenta



COMPATIBLE WITH


  • Stylus D68
  • Stylus D88
  • Stylus DX3800
  • Stylus DX3850
  • Stylus DX4200
  • Stylus DX4250
  • Stylus DX4800
  • Stylus DX4850

FAQs


After single or multiple cartridge installations, the printer performs an automatic cleaning cycle which removes ink from all the cartridges. This process may result in an existing cartridge becoming empty.
Was this answer helpful?
Perform a print head cleaning cycle. This can be located within the printer maintenance menu. Print a nozzle check to see if all the nozzles are free of blockages. If breaks still appear on the printed page, repeat the process. If the nozzle check page displays one set of black nozzles shown below, only perform up to two cleans.
If the screen displays up to three sets of nozzles, perform up to three cleans: 99% of all blocked nozzles are caused by trapped air within the print head. If the cleaning cycle does not remove the lines, rest the printer for half an hour and perform a nozzle check. (Do not continue to clean the cartridges as this will use up valuable ink from all the cartridges).
If there is no improvement, leave the cartridge for a further two hours. During the rest period, ink from the cartridge will migrate through the cartridge and absorb / push trapped air from the print head.
If Epson cartridges are removed from the printer for any length of time, the print head is liable to dry out and block up. Always remove used cartridges when you have a replacement available.
Never remove the power supply when the printer is in operation such as paper feed, cleaning cycle and printing. When the printer is not in use, the print head will park over the ‘capping mechanism’ which seals over the print head preventing it from drying out.
Was this answer helpful?
It is possible that one of the cartridge chips has not connected properly with one of the printer electrical contacts. The printer carriage needs to be placed in the cartridge change position. This can be achieved by either pressing the ink / OK button on the printer or following the step by step cartridge change guide located within the printer maintenance menu
Lift the cartridge location lever and push your finger firmly on the top of the cartridges. If this fails, carefully lift the affected cartridge without breaking the rubber seal at the bottom of the product. Push firmly back into position to re-engage the chip / printer contacts.
Was this answer helpful?
Please remove the cartridge from the printer and using a clean tissue gently wipe the chip.
Was this answer helpful?